WOODPRIME

A high grade, solvent-based blend of synthetic Alkyd Resin and drying oils for the nourishment of wood. Has good adhesion and hiding power.

RECOMMENDED USAGE: INTERIOR and EXTERIOR surfaces.
Used on all raw wooden surfaces. All knots in pine must be treated with Knotting prior to coating.

NOT RECOMMENDED FOR:  Not suitable for use on Supawood or previously painted wood surfaces.

APPLICATION: Thoroughly stir and apply 1 coat of Woodprime to prepared surfaces using a brush, roller or spray at the stipulated spread rates. Allow to dry before overcoating.

PLEASE NOTE: Correct preparation is essential. All surfaces must be sound and prepared in the recommended manner.
For more information on surface preparation contact your closest Paintsmiths store.

SPREAD RATE: ± 7m² per litre per coat
NOTE: The spread rates quoted are approximate and should only be used as a guide as the actual rate will vary depending on the condition and porosity
of the substrate.

OVERCOATING TIME:> 24 hours

NOTE: It is very important that over coating times, as set out for the various products, are adhered to and also that the prevailing weather conditions
are taken into account. Ambient and substrate temperatures, humidity and wind etc. can influence drying times of all coatings. Performance problems
can occur if any of the previous coats have not been allowed to dry properly before being overcoated.

IMPORTANT: To prevent surface contamination, coatings must not be left longer than 48 hours between coats. If environmental or weather
conditions have caused surface contamination, all surfaces must be thoroughly washed down before applying the next coating.

CLEANERS/SOLVENTS: Mineral Turpentine